STARFRIT 024005 Instrucciones De Uso Y Mantenimiento página 7

6. Place one or two cups on the removable cup support directly under the dual spout
portafilter.
NOTE: Ensure that the selector dial is at the '' '' position. Ensure the steam button
is in the release position ''
Plug the power cord into a 120V electrical outlet.
7. Press the ON/OFF switch located on the right side of the appliance to start.
8. Wait until the Coffee light illuminates.
9. Turn the selector dial to the "
NOTE: During continuous operations, the coffee indicator light will likely turn off
due to the inadequate temperature of the water in the boiler, but it does not mean
the unit will stop operating, you may continue to make coffee regardless.
10. After a few moments, the water will flow through.
11. In order to stop the water flow once the cup(s) is/are full, turn the selector dial
manually to the '' '' position. The power light will turn off.
NOTE: The perfect espresso ground coffee will generate a small layer of crema
that floats on top of the espresso following extraction.
WARNING: Do not leave the coffee maker unattended while making coffee as
you may need to operate manually at times!
12. Remove the cup(s).
13. Press the ON/OFF switch to off position.
14. Unlock the filter holder handle by turning clockwise. Remove the filter holder
handle from the appliance.
NOTE: Do not touch the ground coffee filter and the dual spout portafilter when it
is hot.
15. Allow the appliance to cool for 5 to 10 minutes.
16. Wash the ground coffee filter and dual spout portafilter under running water to
remove any remaining residues.
17. Remove the detachable water tank, empty, rinse carefully, dry and place back in the
appliance.
18. Unplug the power cord from the electrical outlet.
HOW TO FROTH MILK & MAKE CAPPUCCINO
Steam function is used to froth milk in order to make cappuccino or latté.
STEPS
Prepare expresso following the HOW TO MAKE ESPRESSO COFFEE steps and place
the espresso coffee into a larger cup.
NOTE: Ensure that the selection dial is at the '' ''position.
1. Take the detachable water tank and fill the water tank with drinking water. The
water level should not exceed the "Max" level (1,2L or 40 oz) as indicated in the
detachable water tank. Replace the detachable water tank in the back of the
appliance. Close the water tank cover lid.
NOTE: Check water level before use and replace the water daily. Do not use
mineral or distilled water.
2. Plug the power cord into a 120V electrical outlet.
''.
" position. The power light will illuminate.
7