Harbor Breeze 40314 Manual De Instrucciones página 5

AssEmbLY INsTRUCTIONs
2. Remove three switch housing screws and lower
the switch housing from the existing fan housing. If
applicable, disconnect the male plug from the motor
housing and the female plug from the switch housing.
Remove the switch housing from the switch housing
plate. (Fig. 2a)
Note: If your existing fan has a switch housing cap,
remove only the switch housing cap by removing
the switch housing screws at the bottom of the
switch housing. (Fig. 2b)
3. Use a screwdriver to push out the center cap from
either the switch housing (Fig. 3a) or the switch
housing cap (Fig. 3b).
4. Gently feed the wires from the light kit fitter (A)
through the hole in the center of the switch housing
(Fig. 4a) or switch housing cap (Fig. 4b). Thread the
rod from the light kit fitter (A) into the switch housing
cap. Then thread the lock washer (BB) and hex nut
(AA) through the wires and tighten the hex nut (AA)
over the lock washer (BB) to secure the rod.
Hardware Used
AA
Hex Nut
bb
Lock Washer
AA
x 1
BB
x 1
5
2a
Motor
Housing
Switch
Housing
Plate
2
Switch
Housing
Cap
3a
Switch
Housing
3
Switch
Housing
Cap
Lowes.com/harborbreeze
Switch
Housing
Motor
Housing
Switch
Housing
Center Cap
Switch
Housing
Cap
Center Cap
BB
Switch
Housing
BB