Basic Functions - Denver TCD-31 Manual De Instrucciones

BASIC FUNCTIONS

Switching power on/off: Save energy
Whether you are using mains or battery supply, to
avoid unnecessary energy consumption always adjust
the source selector to off.
General operation
1 To select your sound source adjust the source
．
selector to CD/(TAPE/POWER OFF)/RADIO
2 Adjust the sound with the VOLUME.
3 To switch off the set, adjust the source selector to
off position.
RADIO
Radio reception
1. Slide the FUNCTION selector to RADIO
2. Slide the BAND selector to a desired setting
- FM .
3. Rotate the TUNING control to find the desired
stations.
4. When you have finished listening, slide the
FUNCTION selector to the (TAPE/POWER OFF) position
to shut the power off.
PLAYING A CASSETTE
1. Select TAPE source.
2. Press STOP• EJECT to open the cassette door.
3. Insert a recorded cassette and close the cassette door.
4. Press PLAY to start playback.
5. To interrupt playback, press PAUSE . To resume, press the key again.
6. By pressing or on the set, fast winding of the tape is possible in both directions.
7. To stop the tape, press STOP•EJECT.
–The keys are automatically released at the end of the tape, except if PAUSE has been activated.
EN-4
All manuals and user guides at all-guides.com
RADIO
– For FM, pull out the telescopic antenna. Incline and
turn the antenna. Reduce its length if the signal is
too strong (very close to a transmitter).
–
GENERAL INFORMATION ON RECORDING
•Recording is permissible in so far as copyright or other rights of
third parties are not infringed.
•This deck is not suitable for recording on CHROME (IEC II) or
METAL (IEC IV) type cassettes. For recording, use NORMAL
type cassettes (IEC I) on which the tabs have not been broken.
The best recording level is set automatically . Altering the VOL
and DBB controls will not affect the recording in progress.
•At the very beginning and end of the tape, no recording will
take place during the 7 seconds, when the leader tape passes
the recorder heads.
•To protect a tape from accidental erasure, have the tape in
front of you and break out the left tab.
Recording on this side is no longer possible. To record over this
side again, cover the tabs with a piece of adhesive tape.
Recording from the radio
1. Tune to the desired radio station (See TUNING TO RADIO
STATIONS ).
2. Press STOP• EJECT to open the cassette door.
3. Insert a suitable cassette into the cassette deck and close the
cassette door.
4. Press RECORD to start recording.
5. For brief interruptions, press PAUSE. To resume recording,
press PAUSE again.
6. To stop recording, press STOP• EJECT.
MAINTENANCE
Tape deck maintenance
To ensure quality recording and playback of the tape deck, clean
parts , and shown in the diagram below, after approx.
A B C
50 hours of operation, or on average once a month. Use a cotton
bud slightly moistened with alcohol or a special head cleaning
fluid to clean the deck.
1. Open the cassette door by pressing STOP• EJECT.
2. Press PLAY and clean the rubber pressure rollers .
3. Press PAUSE and clean the magnetic heads
Capstan .
B
4. After cleaning, press STOP• EJECT.
Note: Cleaning of the heads can also be done by playing a
cleaning cassette through once.
RECORDING
C B A A
C
and also the
A
EN-5