Operation - EAS ELECTRIC EHR2500 Manual De Instrucciones

OPERATION

Verifications prior to use
1. The power cable must not be damaged or broken.
2. Check that the current rating of the socket corresponds to the
requirements indicated in the specification table and that it is properly
grounded; if not, contact an electrician to replace the socket.
Operating instructions
Power On/Standby: Plug in the appliance. A long beep will be heard. Press the
ON/OFF button to enter the high power heating operating state; then press it
again to enter standby mode.
Mode selection: With the radiator switched on, press MODE to select the opera-
ting mode of the appliance (high, medium, low and ECO).
Temperature setting: With the radiator on, press
You can press and hold these buttons to increase or decrease the temperature
faster. After setting the temperature, if no action is taken within 5 seconds the
temperature setting screen will be exited. In initial use or if the appliance is reset
by turning off the power, the radiator operates according to the factory settings:
35°C temperature and high power.
Power-on timer: Press the
the time by pressing
change faster. When the set time is up, the radiator will start and emit a long
beep.
Shutdown timer: With the radiator on, press the
timer. Set the time by pressing
figures change faster. When the set time has elapsed, the radiator will go into
standby mode.
The timer setting range is 0-24 hours, and each press of the
increases or decreases by 1 hour. When the displayed value is 0H, you can press
the button to set it to 24H, and if 24H is displayed, you can press
it to 0H. If the timer is set to 0H, this function is cancelled. After setting the time,
press the timer or MODE button to confirm, or if no action is taken within 5
seconds, you will exit the timer setting mode.
If you have already set a timer, press the standby key
and cancel the timer.
Once the timer has started, press the
the timer and reset it. During the set time, the machine can be switched on or
off with the temperature control without affecting the programming. The set
timer will be cleared in case of power failure.
button in standby mode to activate the timer. Set
and , or by holding them down to make the figures
and , or by holding them down to make the
button to check the remaining time of
6
or to set the temperature.
button to set the shutdown
or
to enter standby mode
buttons
to change
V.1