Hoppe 7517464 Manual De Instrucciones página 11

6. HANDLE SAGS OR RETURNS SLOWLY
Probable Cause: Cladding or wood in the hole is interfering with shaft.
Solution: Check to see if machined holes line up with screw and handle holes. May
need to file or drill hole slightly larger.
7. SET SCREWS WILL NOT GO INTO HANDLE COMPLETELY
Probable Cause: Shaft is not assembled properly.
Solution: Remove handle to see how shaft is assembled. See Handle Set Installation
Instructions for proper assembly and position of shaft.
8. BOTTOM LOCKING POINT MOVES BUT TOP LOCKING POINT DOES NOT
Probable Cause: Top extension drive rail is not connected at the lockcase.
Solution: Remove screws used to attach top extension to the door and the machine
screw that attaches it to the lockcase, and remove top extension. Place the end of
the drive rail (the "L" shape) in the lockcase above the latchbolt, as you slide the top
extension into the door. Fasten with a screw at the lockcase and the one up higher.
Operate the gear to make sure it works. Then finish installing the rest of the screws.
9. IF DOOR HAS PLAY OR IS NOT SEALING CORRECTLY
Probable Cause: Unit is not adjusted properly.
Solution: Bend tab on strike.
Solution: If available adjust Roller (See Adjustment Instructions)
Solution: If available adjust Hinge
10. KEY DOES NOT WORK IN CYLINDER
Probable Cause: Cylinder was rekeyed incorrectly.
Solution: Check with Builder or Installer to see if cylinder was rekeyed to match other
doors in the house. If so, return to locksmith to rekey properly.
Page 11