Hoppe 7517464 Manual De Instrucciones página 16

HOPPE Profile Cylinders
Visit HOPPE North America on YouTube
Introduction
• Rekeying should be done by a qualified
locksmith.
• Cylinder designs vary. HOPPE supplies CES
brand cylinders and non-logo cylinders.
• Cylinders feature Schlage® SC1 keyways
and may be rekeyed using Schlage® rekey
kits.
• Cylinders should be rekeyed to an existing
Schlage® key whenever possible.
• The HOPPE key gauge measures key cuts
1 through 9 the same as a Schlage® key
gauge.
Recommended Tools and Accessories
REMOVAL TOOL
for PLASTIC HEX WRENCH P/N
INSERT
(for use with no-logo
Steps to Rekey
Remove PLASTIC INSERT using
1.
REMOVAL TOOL as shown and
tap out PINS and SPRINGS
2.
3.
• Insert desired CORE PIN into the appropriate
cylinder pin hole.
• Note: for cylinder designs featuring six pin
holes, the innermost hole (furthest from
the key face) is left blank.
• Insert HOUSING PIN
• Insert SPRING
• Repeat until all PINS have been replaced and
install PLASTIC INSERT OR install SET SCREW
and repeat until all PINS have been replaced.
Page 16
Rekeying Instructions
to see a
PLASTIC INSERT
2 mm or 5/64"
Part Number
7065774
(for use with CES
cylinders)
1-888-485-4885 www.hoppe.com
cylinder removal video
• If rekeying a CES cylinder with CES pins, use
the CES pin number that corresponds with the
measured key cut.
• If rekeying a CES cylinder with Schlage® pins,
use the Schlage® pin number that is one less
than the measured key cut. A key cut measur-
ing 4 uses a #3 Schlage® pin.
• If rekeying a non-logo cylinder with Schlage®
pins, then use the Schlage® pin number that
corresponds with the measured key cut.
• If rekeying a non-logo cylinder with CES pins,
use the CES pin number that is one higher than
the measured key cut. A key cut measuring 4
uses a #5 CES pin.
KEY GAUGE
Not offered by
8771719 HOPPE
cylinders)
Determine CORE PIN size with KEYING GAUGE
Contact your local hardware store or search the
Internet for "Schlage Key Guage".
and other helpful
HOPPE REKEY KITS
Schlage® Pins, 30 cyl.
capacity
- P/N 3459001
Remove one SET SCREW at a time
using 2 mm HEX WRENCH as shown
and tap out PINS and SPRING
P/N 7517355
p1312012e065
videos.