Leg Assembly - Desa W32LT Instrucciones De Instalación

leG Assembly

1. Lay right side panel (#2) face down on a soft surface
to avoid marking finish. Attach three brackets with 1/2"
screws to bottom of right front leg (#3) leaving screws
slightly loose. Face brackets out toward tongued side
(see Figure 1). Place right front leg over right side (#2)
matching groove in leg to tongue on side, as shown in
Figure 1, matching trim on side with trim on front. Align
threaded holes with brackets on side. Start three 1/2"
screws through brackets. Align bottom of side and leg
assembly so they are flush with each other. Hold these
pieces securely in alignment while tightening (but not
over tightening) screws.
2. Assemble left side (#4) and left leg (#5) as described in
step 1.
3. Attach 6 brackets to base (#1) at threaded hole locations
using 1/2" screws leaving screws loose. Face brackets
toward outside.
4. Place right side/leg assembly on base and align threaded
holes with brackets. Start 1/2" screws through brackets
into threaded holes in side/leg assembly. Back of side/
leg assembly should be flush with back of base. Assure
alignment is correct and spaces are at a minimum. Leave
screws slightly loose.
1/2" Screw
Leg Side (#4)
Bracket
Groove in
Leg Front
Leg Front (#3)
Tongue on
Leg Side
Figure 1 - right and Left Leg assemblies
2
5. Assemble left side/leg assembly to base (#1) following
step #4.
Tongue on
Leg Side
HeADeR Assembly
1. Using 1/2" screws, secure brackets to two threaded holes
at both ends of header (#6). Turn brackets to the outside.
Leg Front (#5)
2. Place header extension (#6A) onto bottom edge of header
aligning holes in extension with threaded holes in header
Groove in
Leg Front
(see Figure 3). Using two 1
Allen wrench provided, attach extension to header but do
not completely tighten screws.
Bracket
Leg Side (#2)
1/2" Screw
1 1 / "
4
Screw
with
Washer
www.desatech.com
Right
Side/Leg
Assembly
Bracket
1/2" Screw
Figure 2 - Leg assembly to Base
/
1
Header
Extension (#6A)
Figure 3 - attaching Header Extension
Base (#1)
" screws with washers and
4
Header (#6)
119494-01C