Cleaning The Beer Tap Mechanism - Klarstein SKAL Manual De Instrucciones

EN
36

CLEANING THE BEER TAP MECHANISM

The beer dispenser must meet hygienic requirements. It must be cleaned before first
use and after a long period of non-use. Clean the whole machine with a dry cloth. In
addition, there are 2 recommended cleaning instructions:
1. Fill the cleaning set with warm water.
2. Connect the end of the piercing needle. Press the water into the piercing needle to
clean the inlet pipe. Press the water out of the beer hose at the other end. Repeat
until the beer hose is clean. You need at least 3 bottles of warm water). Clean
the dosing mechanism as shown in the picture below. Disassemble the tap when
cleaning.
Dosing mechanism
• When cleaning the beer hose, open the tap.
• This connection must be connected to the cleaning cartridge.
Cleaning cartridge
Note: Never place the dosing mechanism in the washing machine or dishwasher.
Never use chemical detergents to clean the parts. Use as warm, clean water as
possible.
This connector must connect with
cleaning bottle
Please open the faucet when you
are cleaning the beer tube
This connector must connect with
cleaning bottle
Dispensing unit
Cleaning bottle