Level Control - Magnat Cinema Ultra SUB 300-THX El Manual Del Propietario

Power switch On
Operating mode Subwoofer is in permanent operation, the LED is green.
switch ON
Favourable setting for the reproduction of programmes
with long quiet passages (this prevents the subwoofer
from switching off unintentionally).
Operating mode The
AUTO (recommended setting).
The subwoofer switches on automatically when it
receives a signal from the receiver, the LED turns green.
It automatically switches to standby after receiving no
signals for some minutes, the LED turns red.
COnneCtiOn mODe SWitCH (1)
To select the connections used. "THX" for use on THX-licensed devices, "LINE" for use on non-THX-licensed
multi-channel or stereo equipment.
line COnneCtiOnS (5)
For connecting to level outputs on a receiver/amplifier (stereo mode), see Fig. 2.
For connecting to an AV receiver with low-level subwoofer output, see Fig. 3.
Together with the line-in connectors, the subwoofer can be connected between the pre-amp and the power
amp, see Fig. 4.
tHX COnneCtiOnS (4)
For connection to the LFE output of a THX-licensed receiver/amplifier, see Fig. 5.
The "THX Out" allows the signal to be passed on to other subwoofers. If the receiver/amplifier has two LFE
outputs, it is preferable to connect one subwoofer to each of the outputs.

leVel COntrOl (8)

The control has no function in THX mode. This control is used to set the bass volume according to your prefe-
rences. Proceed as follows:
1. Set the bass control of your amplifier into its centre (linear) position.
2. Important: Set the level control to its left stop (lowest volume).
3. Now, play back some music and set the volume control of the amplifier to the desired level.
4. Set the subwoofer level control to the desired bass level.
automatic switching
Power switch OFF
The subwoofer is switched
off, LED is off.
This is the setting for when
subwoofer isn't used over
on/off is activated
long periods.
9