Cembre MG3 Manual De Uso página 3

• Read this manual carefully before using MG3.
• Do not operate MG3 without the lid in place.
• Keep hands away from moving parts during operation.
• Disconnect MG3 from the power supply prior to maintenance operations.
• Use MG3 on a stable surface.
• As much as possible, avoid the ingress of environmental contamination, eg dust, into MG3.
• Always fi t the protective cover when MG3 is not in use, particularly in a dusty environment.
• Do not insert sharp, hard or pointed objects (e.g. screwdrivers, rulers or knives) into the front aperture of MG3, otherwise the
print head may be irrevocably damaged.
• Ensure all parts of the support templates are undamaged and kept clean and free of print and other residue.
• Ensure the carriage is kept clean and closed when MG3 is not in use.
• Do not attempt to change the composition, height or thickness of the support templates as this may block MG3 or Irrevocably
damage the print head.
• Prior to printing, ensure the appropriate template is being used and the material is located correctly so that it does not
hinder the operation of MG3.
• Handle sheets of media with care and avoid touching the printable surface with the fi ngers.
• Before printing, check the printable surface is free of contamination, eg dirt, dust or grease and if necessary clean using a
soft cloth.
• Keep unused or partially used sheets of media in the original packaging and in a dry, clean place.
• When printing partially used sheets, ensure there are no protruding sprues, burrs along the sheared edges or tags bent up-
wards, which may damage the print head.
• When printing partially used sheets, ensure the Jump function is used correctly to avoid printing non-existent media, contami-
nating the support template and possibly causing irrevocable damage to the print head.
• Use only genuine Cembre media, printer ribbons, spare parts and cleaning kits with MG3.
• We recommend cleaning the print head at each ribbon replacement, using only the genuine Cembre CLEANING KIT.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit diff erent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Modifi cations not expressly approved by the manufacturer could void the user's authority to operate the equipment under
FCC rules.
WARNINGS
. 3 .