Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Inserting Batteries
Inserting Batteries
The MB-D14 can be used with one EN-EL15 rechargeable Li-ion battery or with six AA batteries.
Before inserting batteries, be sure that the camera is off and that the MB-D14 control lock is in the L position.
1 Turn the MB-D14 battery-chamber latch to
2 Ready the batteries as described below.
EN-EL15: Matching the indentations on the battery to the projections on the MS-D14EN holder, insert the battery with the arrow (▲) on the bat-
tery toward the battery holder power terminals (Figure F-
the power terminals click into place (Figure F-
AA batteries: Place six AA batteries in the MS-D14 battery holder as shown in Figure G, making sure that the batteries are in the correct orientation.
3 Insert the battery holder in the MB-D14 and latch the battery-chamber cover (Figure H). Make sure the holder is fully inserted before turning the
latch.
4 Turn the camera on and check the battery level in the control panel or viewfi nder. If the camera does not turn on, check that the battery is cor-
rectly inserted.
The EP-5B Power Connector
When using the EP-5B power connector, insert it into the MS-D14EN holder with the arrow (▲) on the connector toward the battery power terminals.
Press the connector lightly downward and slide it in the direction of the arrow until the power terminals click into place (Figure I-
power connector cover and pass the EP-5B power cable through the opening (Figure I-
and remove the battery holder (Figure E).
q
). Press the battery lightly downward and slide it in the direction of the arrow until
w
).
w
).
En
q
). Open the holder
7
Publicidad
Capítulos
Tabla de contenido
