Identification; Product Description And Type Designation; Product Markings; Preparing The Product For Use - Avigilon ES-HD-IPM Manual Del Usuario

• If the installation is NEMA TYPE 4X, the installer
must replace the cable glands of the product
with NEMA TYPE 4X cable glands.
• For all connections, use cables that are able to
withstand temperatures of at least 75°C (167°F).
• The product is designed to house only cameras
that are properly certified.

4 Identification

4.1 Product description and type
designation
The ES-HD-IPM module exploits in an optimal way
the POE and Hi-POE technology, using the power
supplied by the Ethernet cable as the sole source
of power for all the devices connected, thus
ensuring the maximum efficiency and flexibility
of the network system as well as user-friendly
installation and low costs.
The innovative IPM (Intelligent Power
Management) system enables extremely quick and
easy installation with the use of a single Ethernet
connecting cable.
The analog system, with previously installed
camera housings, can be retrofitted on IPM system
simply by changing the slide and the internal
electronics. This enables the digital conversion,
speeding up the installation and thereby
minimizing costs and environmental impact.

4.2 Product markings

See the label attached to the product.
4
5 Preparing the product for
use
Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.

5.1 Unpacking and contents

5.1.1 Unpacking

When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
5.1.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• IPM module
• RJ45 cable
• Instructions manual
5.2 Safely disposing of
packaging material
The packaging material can all be recycled.
The installer technician will be responsible for
separating the material for disposal, and in any
case for compliance with the legislation in force
where the device is to be used.
When returning a faulty product we recommend
using the original packaging for shipping.