Zyxel NWA1100-N Guia De Inicio Rapido página 13

1. Screw the two screws provided with your NWA1100-N into the wall
60mm apart (see the figure in step 3). Use screws with 6mm ~ 8mm
(0.24" ~ 0.31") wide heads. Do not screw the screws all the way in to
the wall; leave a small gap between the head of the screw and the
wall.
The gap must be big enough for the screw heads to slide into the
screw slots and the connection cables to run down the back of the
NWA1100-N.
Make sure the screws are securely fixed to the wall and strong enough to hold the
weight of the NWA1100-N with the connection cables.
2. Adjust the cables.
Run the connection cables down the back of the NWA1100-N as
shown in the following figure.
OR:
Run the connection cables upward and along the edge of the ceiling.
3. Align the holes on the back of the NWA1100-N with the screws on the
wall. Hang the NWA1100-N on the screws.
13