Dometic MAGICSAFE MS 680 Instrucciones De Montaje Y De Uso página 23

MS680
B) Cables for the central locking system are not connected (fig. 9 3 and
fig. 9 4):
➤ Lock the vehicle with the original vehicle remote control.
✓ The vehicle is locked and the alarm system activated.
➤ Press button (fig. 3 2) on the additional remote control within 30 seconds.
✓ The alarm system deactivates the interior monitoring. (The wireless magnetic
contact switches remain active.)
10.2 Deactivating the alarm system
To deactivate the alarm system manually, proceed as follows:
➤ Open the vehicle with your remote control.
✓ The vehicle emits optical signals according to the factory settings.
I
NOTE
If an alarm was triggered, the siren emits a brief acoustic signal (see
chapter "Sorting the alarm memory" on page 21).
Sorting the alarm memory
The alarm system stores triggered alarms. If you hear a short acoustic signal during
deactivation, the alarm system has stored an alarm. You can read the alarm memory
and determine the reason for the alarm.
To do this, proceed as follows:
➤ Switch on the ignition and observe the LED on the base of the electronic key
(fig. 4 1).
✓ The LED shows the reason for the alarm:
LED display
2 x On – 2 s Off – 2 x On
3 x On – 2 s Off – 3 x On
4 x On – 2 s Off – 4 x On
6 x On – 2 s Off – 6 x On
8 x On – 2 s Off – 8 x On
9 x On – 2 s Off – 9 x On
EN
Reason for alarm
Ignition key was activated
Doors opened
Bonnet opened
Ultrasonic module
Wireless magnetic contact switch
Wireless infrared motion sensor
Using the alarm system
Duration of
display
Ten times
Ten times
Ten times
Ten times
Ten times
Ten times
21