Clock - Sanyo ECD-T1820 Instrucciones De Operación

CLOCK

DISPLAY MODE CHANGE
The display on the unit can be changed by pressing CLK button
. Press the CLK button
to switch
between the clock and audio display. When a radio, tape and CD function is performed while the time display
is selected, the audio display will appear for 5 seconds, then the display will return to the time mode.
ADJUSTING THE TIME
To adjust the time, press the CLK button
for more than 2 seconds. The time display blinks.
To adjust the minute, press the
To adjust the hour, press the
To advance the time rapidly, hold the
Press CLK button
again to start the clock.
CLOCK RESET
Press CLK button
for more than 2 seconds and the time display blinks. While blinking, press preset
button 6  to skip to the nearest half-hour as follows:
–
Example: 3:00 3:29
–
3:30 3:59
Notes
• This unit uses a 12-hour clock.
• The clock function and radio presets are retained in memory when the audio is switched off.
......................................... 1
.............................................. 1, 2, 3
button .
button .
or
......................................................... 1, 4
3:00
4:00
4 1
button continuously.
-15-
3 2