Clock - Sanyo FXCD-1100 Instrucciones De Operación

CLOCK

3
DISPLAY MODE CHANGE
The display on the unit can be changed by pushing button
clock and audio display. When a radio, tape or CD function is performed while the time display is selected, the
audio display will appear for 5 seconds, then the display will return to the time mode.
ADJUSTING THE TIME
To adjust the time, press the DISP button
To adjust the minute, press the button
To adjust the hour, press the  button
To advance the time rapidly, hold the or  button continuously.
Press DISP button ➀ again to start the clock.
CLOCK RESET . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
➀
Press DISP button for more than 2 seconds and the time display blinks. While blinking, press preset button
➃
6 to skip to the nearest half hour as follows:
Example: 3:00X3:29 ³ 3:00
3:30X3:59 ³ 4:00
Notes
S This unit uses a 12 hour clock.
S The clock function and radio presets are retained in memory when the audio is switched
off.
1
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
➀
for more than 2 seconds. The time display blinks.
➁
.
➂
.
- 19 -
4
➀ ➀
. Press the DISP button
1
to switch between the
1, 2, 3
1, 4