GRAPHITE PRO 59GP402 Manual Del Usuario página 19

quickly), remove the battery from the
charger, wait for approximately 30 minutes
and put the battery back in the charger. This
temperature rise inside the battery is not
likely and may never occur.
Batteries heat up strongly when charging. Do
not operate just after charging – wait for the
battery to cool down to room temperature. It
will prevent battery damage.
BATTERY LEVEL INDICATION
To check battery level status, press the button
for battery level indication (13) (fig. C). When
all diodes (14) are on, the battery level is
high. When red and yellow diodes are on, the
battery is partially charged. When only red
diode is on, the battery is discharged and must
be recharged.
USB POWER BANK
The battery features Power Bank functionality
that allows to charge external devices (e.g.
phone, mp3 player) with USB port.
When charging external device observe the
device manufacturer guidelines.
Charging with the battery USB port:
• Plug USB cable to an external device.
• Remove the battery USB port cover.
• Plug the USB cable to the USB port in the
battery.
• Press the button for battery level indication
(13) (fig. C). USB will be activated and the
external device charging will start.
• Charging may be stopped automatically
(USB port will be deactivated) when the
battery level is too low.
If the USB port is activated, and there is no
USB device connected for charging, the USB
port will be automatically deactivated after
approximately 40 seconds.
The USB port in the battery is protected
with the cover, which should be in place at
all times when the port is not in use or when
the battery is used to power up dedicated
power tool.
SPINDLE BRAKE
The power tool is equipped with electronic
brake, which stops the spindle immediately
after the switch button (9) is released. The
brake allows for precise driving and prevents
free spindle rotation after it is switched off.
OPERATION / SETTINGS
SWITCHING ON / SWITCHING OFF
Switching on – press the switch button (9).
Switching off – release the switch button (9).
Each time the switch button (9) is pressed,
the LED diode (10) lights up to illuminate the
workplace.
ROTATIONAL SPEED CONTROL
Increase or reduce pressure on the switch
button (9) to adjust rotational speed while
operating. Speed control allows for soft
start, which provides working control during
tightening and undoing bolts.
CIRCUMFERENTIAL IMPACT ACTION
The tool rotates the spindle when tightening,
and creates circumferential impact. Impact
action actuates automatically when the load
increases. Then a high peak torque is applied.
Keep watching the screw or bolt for full control
over tightening. Keep control over tightening
force by adjusting rotational speed.
WORKING TOOL INSTALLATION
• Pull away the fixing sleeve of the tool chuck
(2) (fig. E) against the spring force.
• Insert working tool shank into the tool chuck
(1) and slide it in to mechanical stop (it may
be necessary to turn the working tool so it
can reach appropriate position).
• Release the fixing sleeve of the tool
chuck (2), it will finally lock the working
tool. The fixing
chuck (2) will return to its position
(fig. D).
Deinstallation of the tool is similar to
installation, only the sequence of actions is
reversed.
Use additional driver bit adapter with short
driver bits.
RIGHT-LEFT DIRECTION OF ROTATION
Choose direction of spindle rotation with the
direction selector switch (5) (fig. F).
Clockwise rotation – set the switch (5) to the
extreme left position.
19
sleeve of the tool