Operation And Maintenance; Technical Parameters - GRAPHITE PRO 59GP402 Manual Del Usuario

Counter-clockwise rotation – set the switch
(5) to the extreme right position.
* In certain cases position of the switch related to
rotation may be different than specified. Please refer to
graphic signs located on the switch or tool body.
Safe position of the direction selector switch
(5) is in the middle, it prevents accidental
starting of the power tool.
• When the switch is in this position, the
power tool cannot be started.
• Use this position of the switch to change
bits.
• Before starting the tool make sure the
position of the direction selector switch (5)
is correct.
Do not change direction of rotation when the
spindle of the power tool is rotating.
Long lasting operation at low rotational
speed of the spindle may cause motor
overheating. Provide
during operation or let the tool operate
at maximum speed with no load for
approximately 3 minutes.
HOLDER
The power tool provides convenient holder (6)
that allows to e.g. hang the tool on a tool belt
when working at heights.

OPERATION AND MAINTENANCE

MAINTENANCE AND STORAGE
• Cleaning the device after each use is
recommended.
• Do not use water or any other liquid for
cleaning.
• Clean the power tool, battery and charger
with a dry cloth or blow through with
compressed air at low pressure.
• Do not use any cleaning agents or solvents,
they may damage plastic parts.
• Clean ventilation holes in the motor casing
regularly to prevent device overheating.
• In case of excessive commutator sparking,
have the technical condition of carbon
brushes of the motor checked by a qualified
person.
regular breaks
20
• Store the power tool and its equipment in a
dry place, beyond reach of children.
All defects should be repaired by service
workshop authorized by the manufacturer.

TECHNICAL PARAMETERS

RATED PARAMETERS
Impact Driver
Parameter
Battery voltage
Battery type
Battery capacity
USB Power Bank
Idle rotational speed
Quick-release chuck
Max. torque
Protection class
Weight
Year of production
Charger
Parameter
Supply voltage
Power supply frequency
Charging voltage
Max. charging current
Battery charging time
Protection class
Weight
Year of production
NOISE LEVEL AND VIBRATION PARAMETERS
Noise and vibration information
Parameters of produced noise level, such as
sound pressure level Lp
level Lw with measurement uncertainty K are
A
Value
18V DC
Li-Ion
2500 mAh
5 V DC (1A)
2800 min
-1
6,35 mm (¼ '')
165 Nm
III
1,4 kg
2017
Value
230 V AC
50 Hz
21 V DC
2500 mA
1 h
II
0,58kg
2017
and sound power
A