Installation Steps; Care And Cleaning - LUND Interceptor Instrucciones De Instalación

Installation Steps

Align holes in hood shield with holes in hood in order to
center part in place. Note the location where the bracket
will align with hood edge and mark with a grease pencil.
3
Position hood shield back in place on hood. Ensure that the holes
in hood shield are properly aligned with the holes in the hood and
that the bracket aligns with the protective film.
5
Insert self tapping screw with washer through the hood
shield and into the hood. Securely tighten.
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Lund
and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in terms of
fit, durability, finish and ease of installation.
™
NOTE: Actual application may vary slightly from illustrations.
Remove hood shield.
screw
washer
hood shield
hood
®
branded products offered by Lund International, Inc. We take the utmost pride in our products
800-241-7219 • Visit us at lundinternational.com
© 2012 Lund International, Inc. All rights reserved.
Lund and the Lund
® ®
Center protective film over grease pencil mark, and wrap
4
Insert (1) fastener through the hood shield and into
the hood and securely tighten. Repeat for remaining
6
Slide bracket over hood edge, ensuring that it is centered on the
protective film previously installed in Step 4. Carefully close hood.
8
Lund International
logo are trademarks of Lund International, Inc.
Page 2 of 2
around the hood edge.
fastener.
hood shield
hood
DO NOT OVER TIGHTEN
bracket
protective film
hood
fastener