Plumb Function; Pulse Mode Function - AEG CLG330 Manual Original

PLUMB FUNCTION

With the plumb function, a point on the fl oor can be projected perpendicularly to the ceiling.
The point of reference from the fl oor is aligned to the intersection of the cross line on the
ceiling.
Use the plumb function e.g. to transfer reference point for light installation, vents, transfer of
heights.
ENGLISH

PULSE MODE FUNCTION

For outdoor work under direct sunlight, or bright conditions and for extended indoor ranges of
up to 50 meters / 164 feet, use the pulse mode with a detector.
A detector is not included and must be purchased separately.
When the Pulse Mode is activated the laser beams will fl ash at a very high frequency (invisible
to the human eye) this will allow the detector to locate the laser beams.
1
The pulse mode can be
activated in self-leveling
mode (A) or manual mode (B).
Press the P button, the green
LED next to it will light up.
2
When the Pulse Mode is
switched on, the visibility of the
laser beams are reduced a little
bit.
For information on how to
operate the detector, please
refer to the operating
instructions for the detector.
3
To switch off the Pulse Mode
press the P button again and the
green LED near it will turn off .
A B
A B
8