Wagan Tech Elite 1000W PRO Manual De Usuario página 15

or gases. Failure to heed this warning can result in fire or explosion. Do not
make the positive terminal connection immediately after the batteries have
been charging. Allow time for the battery gasses to vent to outside air.
8. Attach the positive cable to the Positive DC connector on the battery and
then the inverter. Make sure the connections are tight and secure.
9. Turn on the inverter from the Front Panel Power Switch "|"
10. Make certain that the green Operating LED is lit and the FAULT LED
indicator is not lit.
11. Turn Off "O" the inverter. The Fault LED may briefly "flash". This is normal.
The audible alarm may also sound a short "chirp". This is also normal.
12. When you have confirmed that the appliance to be operated is turned off,
plug the appliance into one of the two AC outlets on the front panel of the
inverter.
13. Turn the inverter on.
14. Check operation of the Remote Control switch. Press Lock to turn off the
inverter.
15. Press the Unlock button to turn on the inverter.
16. Turn the appliance on. The appliance should begin working.
17. Observe the LED indicators and the digital display for normal operation.
Note: If an extension cord is used from the inverter to the appliance, limit the
extension cord length to 100 feet or less. Make sure that the cord is safety
approved and AWG 14 or greater to carry the appliance load. Remember that
extension cords are for temporary use.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2015 Wagan Corporation. All Rights Reserved.
14