Troubleshooting - Wagan Tech Elite 1000W PRO Manual De Usuario

Elite 1000W PRO by Wagan Tech
™

TROUBLESHOOTING

PROBLEM: Low or No Output Voltage – Fault LED Lit
Reason
Poor contact with battery, inverter
terminals.
PROBLEM: Inverter Auto Shut Down – Fault LED Lit
Reason
Battery voltage is below 9.5 volts.
Inverter is too hot (thermal shut down
mode).
PROBLEM: Inverter Shut Down – Fault LED Lit
Reason
Equipment being operated draws too
much power.
PROBLEM: Continuous Buzzing Sound
Reason
Input voltage is below 10.5 volts.
Poor or weak battery condition.
Poor or loose cable connection.
Inadequate power being delivered to
the inverter or excessive voltage drop.
17
®
Solution
Clean terminals thoroughly. Reinstall
and tighten.
Solution
Charge or replace battery.
• Allow inverter to cool.
• Check for adequate ventilation.
• Reduce the load on the inverter to
the specified TrueRated
max output.
Solution
Do not use the equipment with this
inverter; use a higher wattage inverter.
Solution
Keep input voltage above 10.5 volts.
Recharge or replace battery.
Inspect terminals and tighten all
connections.
Use heavier gauge DC cables.
Keep cable length as short as possible.
www.wagan.com
power
™