Assembly And Adjustments - Skil 3550 Manual Del Propietário

ASSEMBLY AND ADJUSTMENTS

WARNING
reduce the risk of starting the tool accidentally.
Tile Saw Blade Removal and
Installation
WARNING
blade larger or smaller than 7" diameter, do
not use tile saw blade with speed rating
less than 3600 Rpm. only use smooth edge
tile blade free of openings and grooves.
Tile Saw Blade Removal:
1. Remove the bevel table (Fig. 1).
2. Hold the tile saw blade firmly by hand,
then loosen the nut with nut wrench in a
counterclockwise direction (Fig. 2).
3. Remove outer flange and the tile saw blade.
Tile Saw Blade Installation:
1. Ensure that the shaft and the flanges are
clean.
2. Ensure that the inner flange is properly
positioned on the shaft (Fig. 3).
3. Ensure that the directional arrow marked on
the new tile saw blade is counterclockwise
with the shaft (Fig. 4).
4. Place new tile saw blade on the shaft and
seat the tile saw blade on the rim of the inner
flange (Fig. 3 & 4).
5. Place outer flange on shaft. Rotate outer
flange until it aligns with shaft and slides against tile saw blade (Fig. 3).
6. Tighten the tile blade nut (Fig. 2), but DO NOT OVERTIGHTEN.
7. Ensure the tile blade is secure before using.
Fig. 3
Inner
Flange
Blade must be
seated on rim
of inner flange
Shaft
Blade
16
Disconnect the plug from the power source before making any
adjustments or changing accessories. Such preventive safety measures
To reduce the risk of
injury, do not use tile saw
Fig. 1
Fig. 2
Wrench
Fig. 4
Tile
Blade
Nut
Tile Blade
Direction
Outer
Flange
Bevel Table
Install
Remove
Outer
Flange
Rim of Inner
Flange
Shaft
Remove
Tile Blade
Nut