Trouble Shooter; Environmental Conciderations - THERMEx HARWICH Instrucciones De Uso

B 527428568223082016

TROUBLE SHOOTER

PROBLEM
The hood is not working
The extraction of the range hood is
not sufficient
The letter F flashes in the display
when the hood is in use.
The letter A flashes in the display
when the hood is in use.
ENVIRONMENTAL CONSIDERATIONS
PACKAGING
The packaging must be disposed of in accordance with local regulations on waste management.
SCRAPPING OF THE HOOD
The symbol on the product or accompanying documentation indicates that this product may not be disposed of as household waste but must be
delivered to the nearest collection center for the recycling of electrical and electronic equipment.
POSSIBLE CAUSE
There is no power
The hood is not connected to the power supply
The pressure valve is blocked
The duct is jammed or blocked
The filters are dirty and clogged.
The hood has been in use for 30 hours, and the fil-
ter indicator is therefore activated.
The hood has been in use for 120 hours, and the fil-
ter indicator for the recirculation filters is therefore
activated. This occurs even if recirculation filters
are not used in the hood.
THERMEX HARWICH
SOLUTION
Check the power supply to the hood. Disconnect the power
for approximately 5 minutes and connect again to check if
the fault is still there.
Check that the hood is connected to the power supply. Un-
plug for approximately 5 min, and connect it again to check
if the fault is still there.
Check if objects have fallen down on top of the valve or
whether the clamp around the valve is tightened so hard
that the valve cannot open. Loosen the clamp or remove
the object, if the valve is blocked.
Check the duct, and repair if necessary.
Check if the filters are clean, and clean if necessary. See the
section cleaning and maintenance in this manual.
The filter indicator must be reset manually, as described in
the section MAINTENANCE AND CLEANING.
The filter indicator must be reset manually, as described in
the section MAINTENANCE AND CLEANING.
39