Chicco THERMO DISTANCE Manual Del Usuario página 21

ical
Radiated RF
IEC 61000-4-3
re-
tial
tri-
eral
and
eral
pat-
the
tact
eter
rnal
are
onic
eter
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
ish-
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by
d to
absorption and reflection from structures, objects and people.
plies
a. Field strengths from fixed transmitters, such as base stations from radio (cellular/cordless) tel-
ephones and land mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast can not
be predicted theoretic call with accuracy. To assess the electromagnetic environment due to fixed RF
transmitters, an electromagnetic site survey should be considered. If the measured field strength in
the location in which the Chicco Infrared No Contact Forehead Thermometer REF. 00006931000000
r is used exceeds the applicable RF compliance level above, the Chicco Infrared No Contact Forehead
ent-
Thermometer REF. 00006931000000 should be observed to verify normal operation. If abnormal
performance is observed, additional measures may be necessary, such as reorienting or relocating the
e or
Chicco Infrared No Contact Forehead Thermometer REF. 00006931000000.
ered
b. Over the frequency range 150kHz to 80MHz, field strengths should be less than [V1] V/m.
tive
elds
of a
mer-
3V/m E1= 3 V/m
80MHz to 2.5
GHz
21
Portable and mobile RF com-
munications equipment
be used no closer to any part of
the Chicco Infrared No Contact
Forehead Thermometer
00006931000000, including cables,
than the recommended separation
distance calculated from the equa-
tion applicable to the frequency of
the transmitter.
Recommended separation distance.
d=1.2√P
d=1.2√P 80 MHz to 800 MHz
d=2.3√P 800 MHz to 2.5 GHz
where P is the maximum output
power rating of the transmitter in
watts (W) according to the trans-
mitter manufacturer and d is the
recommended separation distance
in meters (m).
Field strengths from fixed RF trans-
mitters, as determined by an elec-
tromagnetic site survey," should be
less than the compliance level in
each frequency range." Interference
may occur in the vicinity of equip-
ment marked with the following
symbol .
should
REF.