Connecting The Cables - Conceptronic Grab'n'GO Wireless Media Store CH3WNAS Guía De Instalación Rápida

ENGLISH
3) Place the HDD onto the metal bracket, and secure it to the CH3WNAS with the 4
assembly screws.
4) Replace the cover and secure with two screws.

3.2 Connecting the cables

1) Plug the DC power adapter to the DC power connector located on the server's rear
panel, and then connect it to your local power supply.
2) Plug an Ethernet cable to the LAN port located on the server's rear panel, and then
connect it to the network or directly to a computer for configuration.
Note: We advise to connect the CH3WNAS to your DHCP enabled router for easy
configuration. If you connect the device directly to your computer, or to a
network without DHCP server, you need to setup a temporary static IP address
for your computer to configure the CH3WNAS.
See page 12 of the Full Manual (CD-ROM) how to setup a static IP address.
28