Listening To The Radio; Tuning Into Fm Radio Stations; Listening To Dab Digital Radio - Onkyo CS-265DAB Manual De Instrucciones

Listening to the Radio

This manual describes the procedure for using the
remote controller, unless otherwise specified.

Tuning into FM Radio Stations

1 Press the [TUNER] button to change the
input source to FM.
2 While observing the display, press the
[e TUNING]/[TUNING r] buttons to tune
in a station.
Each time you press a TUNING button, the
frequency changes 0.05 MHz steps. If you press
and hold a TUNING button, the frequency will
change continuously. Once you release the button,
tuning will stop automatically when a radio
station is found.
When tuned to a station, the Tuned (
appears. When receiving a stereo FM signal, the FM ST
indicator appears as well.

Listening to DAB Digital Radio

Press the [TUNER] button on the remote
controller, or the [INPUT] button on the top
panel, repeatedly to select "DAB".
„ „ D A„ „ B
When tuned into a DAB station, the Tuned (
indicator appears.
BBC„ „ 5 L„ „ i V„ „ e „
Selecting DAB for the Very First Time
The very first time you select DAB, the Auto Scan
function automatically scans the DAB Band III for the
multiplexes (i.e., stations) available in your area.
Once the scanning process is complete, the first station
that was detected is selected.
Using the Scan Function Manually
If a new DAB station is introduced, or you move to a
new area, you need to run the Auto Scan function
manually.
26
En-
Note:
• When you rescan for DAB stations, the previously-
memorized stations and existing presets will be
cleared.
1 Press the [MENU] button.
2 Use the [q]/[w] buttons to select "Scan >" and then
press the [ENTER] button.
3 Use the [q]/[w] buttons to select World or UK, and
then press the [ENTER] button to start the Auto
Scan function.
If no station is detected after scanning, "No Station"
appears on the display.
Selecting DAB Stations
Use the [e TUNING]/[TUNING r] buttons to
select the DAB stations.
) indicator
BBC„ „ 5 L„ „ i V„ „ e „
Displaying DAB Radio Information
Press the remote controller's [DISPLAY] button
repeatedly to display more information about the
selected DAB station.
1. DLS (Dynamic Label Segment)
When tuned to a station that's broadcasting DLS
text data, the text will scroll across the display.
All„ „ t„ „ h e„ „ „ „ l a„ „ t e
)
2. Program Type
Displays the type of program.
3. Bit Rate and Audio Mode
Displays the station's bit rate and audio mode
(stereo, mono, or joint stereo).
„ „ N e„ „ w s„ „ „ „
64k„ „ b p„ „ s „ „ M „ „ o n„ „ o
(scroll)
„ „