Skil 5995 Instrucciones De Funcionamiento Y Seguridad página 16

SM 1619X07795 06-12_SM 1619X07795 06-12.qxp 6/26/12 7:58 AM Page 16
RIP CUTS
FIG. 14
The combination blade provided with your saw
is for both cross cuts and rip cuts. Ripping is
cutting lengthwise with the grain of the wood.
Rip cuts are easy to do with a rip fence (Fig. 14).
Rip Fence is available as an accessory (not
DESIRED
included). To attach fence, insert fence
WIDTH
through slots in foot to desired width as shown
OF CUT
and secure with the wing nut (not included).
WING NUT
RIP FENCE
RIP BOARD GUIDE
FIG. 15
When rip cutting large sheets, the rip fence
may not allow the desired width of cut. Clamp
or nail a straight piece of 1" (25 mm) lumber to
the sheet as a guide (Fig. 15). Use the right RIP BOARD
GUIDE
side of the foot against the board guide.
DESIRED
LINE
OF CUT
-16-