Sanitas SMA 30 Modo De Empleo página 12

– To turn the appliance on, move the rotary switch to the left (anticlockwise
operation) or right (clockwise operation).
In each case, you can select from two speeds (I and II).
– All file and cutting attachments are coated with a sapphire grain. This guar-
antees extremely long life and almost guarantees freedom from wear.
– Do not exert heavy pressure and always guide the attachments carefully
over the surface to be treated.
– Move the instrument under light pressure in circular movements slowly over
the parts to be treated.
– Note that the cutting attachments will have a reduced effect if the skin is
softened or moist. For this reason, do not carry out any pretreatment in a
bath.
– Do not remove all the callus skin in order to retain the natural protection of
the skin.
– Always ensure that the spindle can rotate freely. It must never be perma-
nently jammed, otherwise the instrument will become too hot and suffer
damage.
– After every use, apply moisturizing cream to the parts treated.
!
Important:
Check the results during treatment. This is particularly important for
diabetics, since their hands and feet are less sensitive.
3.2 Attachments
As these are attachments for use by professionals, we would ask you to han-
dle them with care as they can cause injury when used incorrectly. Particular
caution is advised at higher speeds.
The following attachments are provided with your appliance:
A – Sapphire cone
Removal of dry skin or calluses from the soles of the feet
and from the heels and for manicuring the nails.
B – Felt cone
Smoothing and polishing the edge of the nail after filing
as well as for cleaning the nail surface. Always polish in
circular movements and do not allow the felt cone to
rest in one place, otherwise friction could cause heat
to develop.
1