DeWalt DCC018 Manual Del Usuario página 34

EnGLIsH
Using the Inflator as a Pressure Gauge

CAUTION: Verify the pressure with a suitable pressure
gauge; for example, at your filling station.
1. Connect the high-volume hose
be checked.
2. Press the power switch 2 .
3. The pressure gauge display
item's pressure.
MAINTENANCE
Your D WALT inflator has been designed to operate over a long
e
period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
or external power supply before making any
adjustments or removing/installing attachments or
accessories. An accidental start-up can cause injury.
Repairs
The charger, battery pack and external power supply are
not serviceable. If the inflator will not turn on, check the
battery, all connections, and the fuse in the 12V DC vehicle
connector 19 . The inflator display will show an error code
under certain conditions. Refer to the Troubleshooting Error
Codes chart.
Storage Recommendations
Store the inflator indoors. The best storage place is one that is
cool and dry, away from direct sunlight and excess heat or cold.
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.
Error Code Meaning
LoP Vehicle or external power supply voltage too low or too high
bLo 18 V battery discharged
bAt 18 V battery temperature too low or too high
Er S Pressure sensor fault
OL Pump current too high
OP Pressure exceeded 11 bar
32
10 to the item to
9 will display the
TROUBLEsHOOTInG ERROR CODEs

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Optional Accessories

WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails
to produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care for
our environment:
• Run the battery pack down completely, then remove it from
the tool.
• Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
Solution
Vehicle power – Turn vehicle engine on to increase voltage
External power supply –Replace power supply
Charge or replace battery
Allow battery to rest and return to room temperature
Contact a D WALT authorised service centre.
e
Check for restrictions in hose and connections. If error persists, contact
a D WALT authorised service centre.
e
Check for restrictions in hose and connections
WALT recommended
e