7.3
Mounting the pipework
Connect the components of the filtration system in accordance with Figure
7.3.1 Connecting the pump to the filter
Thread two torro collar clamps around the 47 cm semi-rigid pipe segment. Connect the filter to the pump
using this pipe by pushing the pipe onto the pump outlet hose tail (at the top of the pump) and the filter
inlet hose tail. You may smear the hose tails with silicon oil (supplied) to facilitate installation. Tighten the
clamps to hold the pipe in position.
7.3.2 Connecting the skimmer to the pump
Install the screwed reduction union with the hose tail under the skimmer, apply Teflon to the threading to
create a leaktight seal. The tape should lay flat over the threading. Wind the tape 5 times clockwise around
the threads. Massage the tape into the threading. Unscrew the pump pre-filter and turn over the hose tail to
connect the semi-rigid pipe. Thread two torro collar clamps around the 61 cm, and use this hose segment
to connect the skimmer outlet port to the pump inlet port. Tighten the clamps to hold the pipe in position.
7.3.3 Connecting the filter to the return fitting
Install the solvent reduction union with the hose tail on the return fitting. Proceed as for glueing of the hose
tail to the filter valve detailed in paragraph 7.2.1, page
cm semi-rigid pipe segment, and use this pipe to connect the filter outlet port to the pool return fitting. Run
this pipe under the base of the box as shown in
Caution: to ensure correct operation of the pump, make sure to leave a gap between the pump and
the pool wall.
WOODEN POOLS
Figure 25 – Connecting the filtration system. Filter / Pump / Suction / Return
BWT myPOOL POOL'N BOX
26. Thread two torro collar clamps around the 210
Figure 25
.Tighten the clamps to hold the pipe in position.
2021/02 - Version: D Code : 37311
25.
29/48