Fitting Instructions; Important Information - Dynamics ofa bamberg Instrucciones De Uso

Ocultar thumbs Ver también para ofa bamberg:
Tabla de contenido

Publicidad

Important information

ROM Knee Splint
Introduction
Dear user, we are delighted that you have
chosen an Ofa Bamberg product and we
want to thank you for putting your trust
in us. Please take a moment to read this
product information through carefully to
ensure your Dynamics product works as
effectively as possible.
Ofa Bamberg wishes you a
speedy recovery!

Fitting instructions

The pictures that go with the fitting instructions
can be found on the inside cover (2) at the start
of the brochure.
1
To put the product on, open all of the Velcro fasteners
and the fabric cuff. When putting the product on, please
be aware that the cuff gets narrower at the lower end.
Place the splint against the back of the leg so that the
ROM joints are positioned in line with the middle of
the knee.
2
First close the wide cuff on the lower leg, then the
one on the thigh. Then close the two narrow cuffs.
3
Then close the Velcro straps in the same order by
inserting them through the eyelet provided and
fastening them tightly. If necessary you can then
adjust the cuff and the Velcro fasteners until the splint
is correctly positioned. Ensure that the product is
secure but not too tight so as to prevent pinching.
Intended Use
The Dynamics ROM Knee Splint
fixes your knee in a position that can
be individually defined after injuries or
operations. A suitable Range of Motion
(ROM) can be set using the ROM joints to
ensure early mobilisation of the knee joint.
Soft fabric cuffs provide a high level of
wearing comfort and the open design makes
it easy to put on and take off.
Important information
– The initial fitting and adjustment of the product
as well as instructions on its proper and safe use
should be provided by trained medical/orthopaedic
specialists.
– The product should only be used for the indications
in the adjacent column.
– Check the product to ensure it is working and
check it for wear and damage before each use. You
should also ensure it is fitted correctly. Do not use
a product that is damaged.
– Wear the product directly on the skin. It should
only be worn over intact skin. If it is to be worn in
combination with other products, please discuss this
with your doctor first.
– Unless otherwise prescribed, the product should
be removed during long periods of rest (e.g. when
sleeping).
– If you experience an unpleasant sensation, severe pain
or other symptoms while wearing the product, remove
it and contact your doctor or specialist supplier.
– We use a comprehensive quality assurance system
to check our products. If you have any complaints,
however, please contact your specialist supplier.

Publicidad

Tabla de contenido
loading

Tabla de contenido