Ubbink Eli-Indoor 200i Manual De Instrucciones página 4

Safety requirements
• The power supply must comply with the product specifications. Check your local power company's regulations for the
connection information. If there are any anomalies in the pump or the power cable: do not connect!
• Never carry the pump by the cable and never pull on the pump's cable.
• Never remove the plug or shorten the cable. The guarantee will not be valid if you do so.
• Keep the connection (plug and socket) dry.
• The pump is not suitable for use in swimming pools and lakes or other situations in which people can make contact
with the water, and may therefore not be used for such purposes.
• When cleaning the pump or maintaining the indoor fountain, always disconnect the power first.
• This pump is suitable for moving water with a minimum temperature of 4°C and a maximum temperature of 35°C.
• The electric cable cannot be replaced. If the cable is damaged, the pump must be destroyed.
• The pump may not run dry. This could lead to irreparable damage.
Maintenance and cleaning
• The pump requires no lubrication or particular maintenance. It is sufficient to periodically check the inlet slits on the
filter housing for dirt and clean these with clean water.
• If the pump is extremely dirty, it should be disassembled and cleaned thoroughly.
- if the filter foam becomes dirty, clean thoroughly with clean water
- do not allow the pump to freeze
- do not allow the plug to become wet
4