What do I do if ...
... no weight is displayed when there is
a weight on the scale?
Is the scale switched on?
Check the batteries
0. 0 00
...
does not appear before weigh-
ing?
Switch the scale off and back on again,
making sure there is no load on the scale.
... one segment comes on permanently
or not at all?
This segment is faulty. Inform Servicing.
...
appears in the display?
Battery power is dropping. You will need to
replace the batteries within the next few
days.
batt
...
appears in the display?
The batteries are flat. Insert new batteries.
St0p
...
appears in the display?
The maximum load has been exceeded.
...
appears in the display?
The ambient temperature of the scale is too
high or too low. Place the scale in an ambi-
ent temperature between +10 ˚C and
+40 ˚C. Wait about 15 minutes until the
scale has acclimatised to the ambient tem-
perature and then weigh again.
Er:011:
...
appears in the display?
The scale is overloaded or the load is une-
venly distributed. Take the load off the scale
or distribute weight more evenly and restart
scale.
Er:012:
...
appears in the display?
The scale was switched on with too great a
load on it. Remove load and restart.
Technical data
Dimensions
Depth:
Width:
Height:
Weight
approx. 3.2 kg
Temperature range
+10 °C to +40 °C
Maximum load
20 kg / 44 lbs
Graduations
0 up to 10 kg /
0 up to 22 lbs:
10 up to 20 kg /
22 up to 44 lbs:
10 g / 0.5 ozs
Accuracy
better than ±0,3% / ±10 g
Tare range
up to10 kg / 22 lbs
Auto Hold function
Power supply
mains unit (option)
Power consumption
approx. 25 mA
Accessories
Plug-in mains unit
Use only seca original plug-in mains units
with 9 V or controlled 12 V output voltage.
Commercially-available mains units may
supply a higher voltage than stated and
358 mm
thus lead to damage to the scale.
620 mm
190 mm
Plug-type mains adapter, Euro: 230V~ /
50Hz / 12V= / 130mA,
order no. 68-32-10-252
Switchmode power adapter, 100-240V~ /
50-60Hz / 12V= / 0.5A
seca no. 68-32-10-265
5 g / 0.2 ozs
Head and foot rest
order no. 418-00-00-009
yes
battery/
9