Sauder Shoal Creek Serie Manual De Instrucciones página 2

Table of Contents
Part Identifi cation
Hardware Identifi cation
Assembly Steps
Français
Español
Safety
Warranty
Part Identifi cation
å
While not all parts are labeled, some of the parts will have a label or an inked letter on the edge
to help distinguish similar parts from each other. Use this part identifi cation to help identify similar parts.
A2 RIGHT END (1)
B2 LEFT END (1)
C2 UPRIGHT (1)
D2 TOP (1)
E2 BOTTOM (1)
F2 MODESTY PANEL (1)
G RIGHT FRONT/LEFT REAR LEG (2)
H LEFT FRONT/RIGHT REAR LEG (2)
I PENCIL DRAWER FRONT (1)
N DRAWER FRONT (1)
S2 LARGE DRAWER FRONT (1)
Page 2
Assembly Tools Required
2-3
4
5-24
25-28
29-32
33-34
35
W DRAWER BOX FRONT (1)
X END MOLDING (2)
Y3 HUTCH RIGHT END (1)
Z3 HUTCH LEFT END (1)
AA3 HUTCH UPRIGHT (1)
BB2 HUTCH SHELF (1)
CC HUTCH BACK (1)
DDD DRAWER BRACE (1)
D14 LARGE DRAWER RIGHT SIDE (1)
D15 LARGE DRAWER LEFT SIDE (1)
D30 DRAWER RIGHT SIDE (1)
409733
No. 2 Phillips Screwdriver
Tip Shown Actual Size
Hammer
Not actual size
D31 DRAWER LEFT SIDE (1)
D77 DRAWER BACK (1)
D78 LARGE DRAWER BACK (1)
D83 PENCIL DRAWER RIGHT SIDE (1)
D84 PENCIL DRAWER LEFT SIDE (1)
D121 PENCIL DRAWER BACK (1)
D716 DRAWER BOTTOM (2)
D726 PENCIL DRAWER BOTTOM (1)
EE FOOT EXTENSION BLOCK (1)
www.sauder.com/services