Makita 3710 Manual De Instrucciones página 7

Circular work
1
4
5
Circular work may be accomplished if you assemble the
straight guide and guide plate as shown in the figures.
Min. and max. radius of circles to be cut (distance
between the center of circle and the center of bit) are as
follows:
Min.: 70 mm (2 - 3/4")
Max.: 221 mm (8 - 11/16")
For cutting circles between 70 mm (2 - 3/4") and 121 mm
(4 - 3/4") in radius.
For cutting circles between 121 mm (4 - 3/4") and 221
mm (8 - 11/16") in radius.
1
4
5
NOTE:
• Circles between 172 mm (6-3/4") and 186 mm
(7-5/16") in radius cannot be cut using this guide.
Align the center hole in the straight guide with the center
of the circle to be cut. Drive a nail less than 6 mm (1/4")
in diameter into the center hole to secure the straight
guide Pivot the tool around the nail in clockwise direction.
006619
1. Wing nut
2. Guide plate
3. Straight guide
4. Center hole
5. Bolt
2
3
006620
1. Wing nut
2. Guide plate
3. Straight guide
4. Center hole
5. Bolt
2
3
006637
1. Nail
2. Center hole
3. Straight guide
1
2
3
Trimmer guide
Trimming, curved cuts in veneers for furniture and the like
can be done easily with the trimmer guide. The guide
roller rides the curve and assures a fine cut.
Loosen the wing bolts and secure the tool base horizon-
tally. Install the trimmer guide on the tool base with the
clamp screw (A). Loosen the clamp screw (B) and adjust
the distance between the bit and the trimmer guide by
turning the adjusting screw (1 mm (3/64") per turn). At
the desired distance, tighten the clamp screw (B) to
secure the trimmer guide in place.
1
2
3
4
When cutting, move the tool with the guide roller riding
the side of the workpiece.
1
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.
7
006648
006638
1. Clamp screw (A)
2. Adjusting screw
3. Clamp screw (B)
4. Trimmer guide
5. Wing bolt
5
001998
1. Workpiece
2
2. Bit
3. Guide roller
3