Fig. 1 - GIESSE GS AP002 Instrucciones

PREPARATION
1) With the door closed, mark a horizontal axis "T-T" at a distance of recomended from the finished floor (fig. 1). This height is
recommended in order to avoid cutting the casing of the lower rod when fitting the additional lock points.
2) Carefully fix, on the door, the templates given on page 8 (fig. 1), centering them with respect to the axis "T-T".
In case of single door:
a) the template of the mechanism must be centered with respect to the axis Vp (fig. 1).
In case of double door:
b) for the main wing refer to the operations given in points a).
c) for the secondary wing, position the template relevant to the axis "T-T" at a distance of 51 mm from the edge of the
upright. The distance of 51mm is a recommended value.The installer can establish a different distance according to
the type of profile used and the size of the secondary wing.

Fig. 1

Axis "T-T"
Vp
3) Install the mechanisms on the door as follows:
in case of single door, carry out the operations in point 3a)
in case of double door, carry out the operations in points 3a) and 3b).
3a) Installation of main wing mechanism
Emergency Opener without External Control (fig. 2)
4 Ø3 holes
1 Ø20 holes
Emergency Opener combined with External Control (fig. 3)
4 Ø3 holes
2 Ø10 through holes
1 Ø20 through hole
1 Ø8,5 hole (in outside of door only)
3b) Installation of secondary wing mechanism (fig. 4)
4 Ø3 holes
1 Ø20 holes
Important
If the shape of some profiles does not allow 2 of the 4 Ø3 holes to be made,
make holes A of Ø3, as indicated on the template, and use self-tapping
flathead screws for fixing.
At least 4 screws are always necessary for correct fixing of the
mechanisms.
ISTRUZIONI - INSTRUCTIONS - INSTRUCTIONS - INSTRUCCIONES
PREPARATION AND CHECKS PRIOR TO INSTALLATION
Main door
- 15/40 -
Vp Vs
Secondary door
Fig. 2
Fig. 3
Fig. 4
Vs
I0326001/03-2018