Operating Charger - TJEP RC20A Manual De Instrucciones

Operating charger

Standby
Charging
Finish
Battery high
temperature
Battery low
Red/green
voltage
• Plug the battery charger into the proper AC voltage source. Charging light will start blinking green.
• Insert the battery cartridge into charger.
• When the battery cartridge is inserted, the red charging light will light up and charging will begin.
• When the battery is charged, the charging light will change from red to green.
• After charging, remove the battery cartridge from charger and unplug the charger.
NOTE! The battery charger is for charging TJEP-battery cartridge. Never use it for other
!
purposes or for other manufacturer's batteries. If charging light flashes red/green, battery
condition is as below and charging may not start.
• Battery cartridge from just-operated tool or battery cartridge that has been left in a location expo-
sed to direct sunlight for a long time.
• Battery cartridge that has been left for a long time in a location exposed to cold air.
• When the battery cartridge is too hot, charging will begin after the cooling fan installed in the
charger cools the battery cartridge. Charging will begin after the battery cartridge temperature
reaches the degree at which charging is possible. When the temperature on battery is more than
approx. 50°C - 70°C, two charging lights may flash in red color, and when approx. 50°C – 70°C,
one charging light in red color.
If the charging light flashes alternately in green and red color, charging is not possible. The termi-
nals on the charger or battery cartridge are clogged with dust or the battery cartridge is worn out
or damaged.
Indicators
` Green LED flickering
` Red LED on
` Green LED on
` Red & green LED on
Meaning
` Battery charging is workable
` Battery is being charged
` Fully charged
` Battery temperature has missed the normal
area. Charge will automatically start when
allowable temperature is reached.
` Battery capacity level too low to initiate
charging cycle.
English
129