Maintenance Of The Main Unit; Troubleshooting - Charger; Abnormal Display Mode Function - Charger; Tjep Rc20A/Rc30A Blade - TJEP RC20A Manual De Instrucciones

Maintenance of the main unit

Clean the entire unit occasionally by removing dust, debris and oils. Occasionally remove the flush
cutting bottom plate; then remove any cutting chips that remain lodged in the area the cutting blade
rotated.
It is also recommended that the cutting blade be removed and inspect for any materials that did not
exit out the chip exhaust area. This should be done after 4-8 hours of use. Most material cutting
chips would normally exit out the chip exhaust area and into the bag. It is recommended that the bag
be emptied when it becomes 2/3 full of cut material.

Troubleshooting - charger

• If the LED lamp does not work.
◦ Check connection of power cord into the outlet.
◦ Check the cleanliness of power cord and battery terminal.
◦ Insert another battery to check the charger working normally.
• The green LED flickering when the battery is applied.
◦ Low temperature: Let stand at room temperature until normal temperature.
If checking does not solve the problem, please contact Kyocera Unimerco Fastening or an authori-
zed service center nearest you.

Abnormal display mode function - charger

In case of abnormal mode during operation, the battery capacity indicator LED light
shows the current status of the tool.
LED operation automatically turns off after 10 seconds.
Symptoms
Terminal contact
failure
High temperature
battery protection
High temperature
switch protection
Overcurrent
shutdown
Motor sensor
recognition error
Undervoltage battery
protection

TJEP RC20A/RC30A blade

The blade for the TJEP RC20A/RC30A Rod Cutter should be replaced when the blade is dull or
chipped and a noticeable increase in cutting time has occurred.
To change the blade, remove battery, remove the 4 screws (pos. 1) that hold the blade cover to the
body (4). Remove the cover (pos. 2) and unscrew the 4 bolts (pos. 3) holding the blade to the hub.
LED off
LED 3 space; On 0.7s / Off 0.3s
LED 3 space; On 0.3s / Off 0.7s
LED 3 space; On 0.05s / Off 0,1s
On 0.2s / Off 0,65s (2 flashing)
LED 3 space; On 0.5s / Off 0.5s
LED 1 space; On 0.5s / Off 0.5s
LED indicator
English
131