V-TAC VT-4121 Instrucciones De Instalación página 9

SURFACE MOUNTED MAGNETIC TRACK INSTALLATION
Accessories required for surface mounted magnetic track installation:
NO NAME
4x30mm Tapping
1.
Screw
1.Please refer to the track installation diagram for the hole positions(fig 1). And refer to the table
below for dimension spacing of the holes for surface magnetic track.
FIG 1
2. Mark hole position and drill holes with tools in
the track installation area. Make sure to drill
outlet holes for power cables (Ref Fig 2).
4. Connect the power cables from the track to
the track power connector box, and push the
excess cables into the ceiling from the outlet
hole. Please refer to the installation instructions
of the External power supply installation for
wiring connections.
PICTURE
FIG 2
FIG 4
SIZE
For track installation and fixed use
4x30mm
Dimension spacing table of the holes fo surface
magnetic track:
SKU/Length
7950 / 0.5M
7951 / 1M
7953 / 1.5M
7952 / 2M
3. Install the track into the ceiling with self-tap-
ping screws and the power cord enters through
the hole of the track outlet. Ensure the screw is
firmly installed with the track (Ref Fig 3).
5. Load the magnetic track lights into the track
then switch on the power to test the light.
2 2
ENGLISH ENGLISH ENGLISH ENGLISH
DESCRIPTION
FIG 3
FIG 5