Technical Data - LaserLiner SuperCross-Laser 2 Manual De Instrucciones

Horizontal and vertical levelling:
Release the transport restraint, put the ON/OFF switch (4) into its "ON" position. The cross laser will
appear. The desired laser lines can be selected with the selection button (5). Refer to Figures A, B
and C on page 2 for application examples.
Important: The tilt function must be activated to perform horizontal and vertical levelling. Activate
this by releasing the transport restraint, put the ON/OFF switch (4) into its "ON" position. The tilt func-
tion will produce an alarm when the unit is outside its automatic levelling range of 4.5°. The alarm sig-
nal is audible and the lasers will shut off. When this happens, place the unit on a more even surface.
Slope mode:
Do not release the transport restraint, put the ON/OFF switch into its "OFF" position. Select and
switch on the laser with the selection button (5). Now slopes can be laid out. Refer to the applicati-
on example in Figure D on page 2. IMPORTANT: This mode cannot be used to perform horizontal
or vertical levelling because the laser lines are no longer automatically aligned.

Technical Data

Automatic levelling range
Accuracy
Operating range (depending on room illumination)
Laser wavelength
Laser class / line laser output power
Power supply
Operating time
Temperature range, operating / storage
Dimensions (W x H x D)
Weight (without wall bracket and batteries)
Order number
EU directives and disposal
This device complies with all necessary standards for the free movement of goods within the EU.
This product is an electric device and must be collected separately for disposal according to the
European Directive on waste electrical and electronic equipment.
(Subject to technical changes without notice 04/2010)
+ 4,5°
+ 5 mm / 10 m
20 m
635 nm
2 / < 1 mW
4 x 1,5V alkaline batteries (type AA, LR6)
approx. 60 h
0°C ... +50°C / -10°C ... +70°C
64 x 140 x 87 mm
0,36 kg
081.120A
ENGLISH
SuperCross-Laser 2
9