Starting/Stopping The Blower; Operating The Blower; Maintenance; General Maintenance - Craftsman 315.CR2100 Manuel Del Operador

If depleted, the battery pack will begin charging when
placed on the lithium-ion charger.
CaUTION:
To reduce the risk of injury, charge
only Craftsman lithium-ion batteries and Craftsman
nickel-cadmium batteries on the chargers listed in
the General Safety Rules. Other types of batteries
may burst, causing personal injury or damage.

STarTING/STOppING THe BLOwer

See Figure 4.
 To start the blower, place the power switch in the ON
( l ) position.
 To stop the blower, place the power switch in the OFF
( O ) position.

OperaTING THe BLOwer

See Figure 5.
 To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the
center of a pile.
warNING:
When servicing use only identical
Craftsman replacement parts. Use of any other parts
may create a hazard or cause product damage.
warNING:
Always wear eye protection with side
shields marked to comply with ANSI Z87.1, along
with hearing protection. Failure to do so could result
in objects being thrown into your eyes and other
possible serious injuries.
warNING:
To avoid serious personal injury, always
remove the battery pack from the tool when cleaning
or performing any maintenance.

GeNeraL MaINTeNaNCe

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
warNING:
Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating
oils, etc., come in contact with plastic parts. Chemi-
cals can damage, weaken or destroy plastic which
may result in serious personal injury.
All manuals and user guides at all-guides.com
OperaTION
 To reduce sound levels, limit the number of pieces of
 Use rakes and brooms to loosen debris before blowing.
 Conserve water by using blowers instead of hoses for
 Watch out for children, pets, open windows, or freshly
 After using blowers or other equipment, CLEAN UP!

MaINTeNaNCe

Only the parts shown on the parts list are intended to
be repaired or replaced by the customer. All other parts
should be replaced at a Sears Service Center.
BaTTerY paCK reMOVaL aNd preparaTION FOr
reCYCLING
 Clean all foreign material from the blower.
 Store indoors in a place that is inaccessible to children.
9 — English
equipment used at any one time.
In dusty conditions, slightly dampen surfaces when
water is available.
many lawn and garden applications, including areas such
as gutters, screens, patios, grills, porches, and gardens.
washed cars, and blow debris safely away.
Dispose of debris properly.
warNING:
Battery tools are always in operating
condition. Therefore, switch should always be in the
OFF position when not in use or carrying at your
side.
warNING:
Upon removal, cover the battery pack's
terminals with heavy-duty adhesive tape. Do not
attempt to destroy or disassemble battery pack
or remove any of its components. Lithium-ion and
nickel-cadmium batteries must be recycled or dis-
posed of properly. Also, never touch both terminals
with metal objects and/or body parts as short circuit
may result. Keep away from children. Failure to
comply with these warnings could result in fire and/
or serious injury.
Keep away from corrosive agents such as garden
chemicals and de-icing salts.