Sunbeam SD113232 Instrucciones De Montaje página 12

M
63
66
long
wire
M
Remove the following parts from the carton:
Two COOKING GRIDS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .(63)
Set the COOKING GRIDS (63) into the bottom casting.
63
N
Remove the following parts from the carton:
One WARMING RACK . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .(65)
One TOP WARMING RACK . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .(66)
long
Insert the long wire on the WARMING RACK (65) into the left side of the lid. Hold the
wire
rack in a vertical position and insert right side into the lid.
To center the rack, slightly bend the pivot wires to adjust for a tight fit.
Lower rack and press the pivot wires into side holes. See detail N1.
pivot wire
Insert the long wire on the TOP WARMING RACK (66) into the upper holes in lid.
Hook the top pivot wire into bottom rack and to center, slightly bend wire for tight fit.
65 See detail N1.
N1
pivot wire
66
65
(Pg. 12) 1141-1986