Cognex In-Sight VC200 Manual página 21

3. Connect the Power and I/O cable's M12 connector to the DS1000 series
sensor.
4. Connect the Ethernet cable's M12 connector to the DS1000 series sensor.
5. Connect the Ethernet cable's RJ-45 connector to one of the vision
controller's CAM ports.
Note: Your specific configuration and firmware version may support
between 1 and 4 sensors. Regardless of how many sensors your
device supports or how many sensors you connect, you should
always connect the first sensor to port 0, the second sensor to port 1,
and so on.
20