About This Document; General Safety Precautions - STEINEL 4007841058661 Manual De Instrucciones

GB

1. About this document

– Please read carefully and keep in a safe place.
– Under copyright.
Reproduction either in whole or in part only with our consent.
– Subject to change in the interest of technical progress.
– All product dimensions in mm.
Symbols
!
Hazard warning!
Reference to other information in the document.
...

2. General safety precautions

!
Disconnect the power supply before attempting any work on the unit.
• Only use genuine replacement parts.
• Repairs may only be made by specialist workshops.
• Not suitable for use with halogen lamps.
3. Way/Garden
Proper use
– Outdoor LED light for mounting on the ground.
– For connection to an IP44 power socket.
Way NightAutomatic spot / Garden NightAutomatic spot
– The sensor-switched LED light contains a light-level sensor.
Way Sensor Connect spot / Garden Sensor Connect spot
– The sensor-switched LED light contains an infrared motion detector and can only
be adjusted via Bluetooth and app.
Way spot package contents (Fig. 3.1)
– Light including pillar, ground plate and power cord cable with mains plug
– Three screws
– Three ground plugs
– 18 –
Garden spot package contents (Fig. 3.2)
– Light including power cord cable with mains plug
– Ground spike
– Two screws
Way spot product dimensions (Fig. 3.3)
Garden spot product dimensions (Fig. 3.4)
Product parts (Fig. 3.5 – 3.10)
A Light enclosure
B Motion sensor (Way/Garden Sensor Connect spot only)
Light-level sensor (Way/Garden NightAutomatic spot only)
C
D Twilight setting (Way/Garden NightAutomatic spot only)
E Pillar with ground plate (Way spot only)
F Ground spike (Garden spot only)
G Mains power cord with plug
Detection zone for Way/Garden Sensor Connect spot (Fig. 3.11 – 3.16)
4. Installation
• Check all components for damage.
• Do not use the product if it is damaged.
• This light's external, flexible cord cannot be replaced.
If the cord gets damaged, the entire light must be replaced.
• When installing the light, make sure the installation site is not subject to vibration.
• Select an appropriate mounting location, taking the reach and motion detection
into consideration.
Way/Garden Sensor Connect spot only:
The most reliable way to detect movement is given by mounting the light to point
across the direction in which people walk and by making sure no obstacles (e.g.
trees, walls etc.) interrupt the line of sensor vision.
Way mounting procedure
• Fit floodlight head on pillar and turn until it clicks into place. (Fig. 4.1)
• Mark drill holes for ground plate. (Fig. 4.2)
• Drill holes and fit ground plugs. (Fig. 4.3)
• Procedure for mounting light on ground. (Fig. 4.4)
• Connect plug. (Fig. 4.5)
• Make settings. ➜ „5. Function"
– 19 –