STEINEL 4007841058661 Manual De Instrucciones página 11

Mounting procedure for Garden
• Attach ground spike to light. (Fig. 4.6)
• Push light into ground. (Fig. 4.7)
• Connect plug. (Fig. 4.8)
• Make settings. ➜ „5. Function"
Information for NightAutomatic version
• Make sure that the light-level sensor is not covered (e.g. by leaves).
5. Function
Way NightAutomatic spot / Garden NightAutomatic spot
Factory settings
– Control dial set to = permanently ON
Twilight setting (Fig. 5.2 D)
The light's chosen response threshold can be infinitely varied from
approx. 2 to 1000 lux.
– Control dial set to = permanently ON
– Control dial set to = night-time operation (approx. 2 lux)
For performing the functional test in daylight, the control dial must be set to
Way Sensor Connect spot / Garden Sensor Connect spot
Factory settings
– Twilight setting: 2000 lux
– Time setting: 5 seconds
Smart Remote app
To configure the light via smartphone or tablet, you must download the STEINEL
Smart Remote app from your app store. You will need a Bluetooth-capable smart-
phone or tablet.
Android iOS
– 20 –
Following functions can be set via Smart Remote app:
– Time setting
– Twilight setting
– ON and OFF times
– Automatic/manual control, depending on situation
– Interconnection
– Grouping
– Naming groups and lights
Note:
After the light switches OFF, it takes approx. 1 second before it is able to start detect-
ing movement again. The light will only switch ON in response to movement once this
period has elapsed.
The Connect spot has an internal clock for time-based activation and deactivation.
This automatically synchronises with the clock of the connected smartphone via the
Smart Remote app each time a Bluetooth connection is established.
To ensure correct function following an interruption in the light's power supply, it must
be re-connected via the Smart Remote app. The internal clock is re-synchronised
with the smartphone clock.
6. Light tilting/swivelling range / Changing lamp
.
Light tilting/swivelling range
– Way (Fig. 6.1)
– Garden (Fig. 6.2)
Changing lamp
• Undo glass cover and detach from light enclosure. (Fig. 6.3)
• Disconnect and remove lamp. (Fig. 6.4)
• Insert new lamp and twist to engage. (Fig. 6.5)
• Fit glass cover and twist to engage. (Fig. 6.6)
Important:
Only use GU10 LED lamp with a wattage up to 9 W.
Note:
• On changing a lamp, make sure that the seal and sealing surface are not soiled or
damaged.
7. Maintenance
The product requires no maintenance.
The light can be cleaned with a damp cloth (without detergents) if dirty.
– 21 –