Switching On/Off; Comb Attachment; Cleaning And Care - exonda OT10 Manual De Instrucciones

3 Operation
3.1 Switching ON /OFF
– Image A: in order to switch the appliance on, push the on/off switch 4 forwards.
– In order to switch the appliance off, push the on/off switch to position 0.
NOTE for model OT11B:
With model OT11B, the LED lighting 5 for the cutting area automatically switches
on/off.
3.2

Comb attachment

– Image B: switch off the trimmer and push the comb attachment 12 onto the
cutter head 6 until it clicks into place.
– You can then cut hair with the trimmer as usual.
– Image C: the comb attachment 12 can be set to 4 different cutting lengths
(approx. 3 to 6 mm). To do this, push it to the desired position on the cutter
head 6.
The further the comb attachment 12 is pushed inwards, the shorter the cutting
length.
4

Cleaning and care

To ensure perfect functioning and full performance of your trimmer, clean and oil the
appliance regularly.
Cleaning and oiling the cutter head
If you use the appliance regularly, the cutter head 6 should be thoroughly
cleaned and oiled once a day.
– Switch off the appliance.
– Remove the comb attachment 12, if necessary.
– Remove any hair using the cleaning brush 14.
– Image D: oil the areas where the bottom and top cutting blades touch.
NOTE for model OT11B: when oiling, ensure that no oil gets in between the
housing and the LED lighting 5.
Removing the cutter head
The cutter head 6 should additionally be removed at regular intervals, in order
to carefully remove residual hair particles from the interior using the cleaning
brush 14.
Models OT11 / OT11B / OT14
– Ensure that the on/off switch 4 is set to 0.
– Removing: image E: press on the top of the cutter head 6 with your thumb to
push it off the appliance.
– Mounting: place the cutter head 6 on at the bottom and swing it upwards
until it clicks into place.
ENGLISH 15