Transducer Installation; Transom Installation - Plastimo ECHOFISH 600 Manual De Instalación Y Funcionamiento

A- Display unit
B- Bracket
C- Upper twist base
D- Lower twist base
E- Locking bolt
F- Toothed connector
G- Toothed connector
H- Transducer
I- Pivot
J- Template
K- 3x8mm screws
L- 5x20mm screws
M- Nut
N- 4x15mm screws
O- Pivot bolt

Transducer installation

1. Transom installation

1.1 Select the mounting solution
When choosing the transducer mounting location, do not
forget to consider the flowing as well. The sonar transmis-
sion/reception can be affected severely in turbulent waters.
Never mount the transducer behind rows of rivet, water in-
take, discharge port, propeller area, etc. These areas can
create turbulences when the boat moves a t a high speed.
1.2 Mark the location and drill the mounting holes
Make sure the boat is flush and parallel with the water sur-
face.
Hold the template against the transom of the boat, mark
two holes in both slots. The center of both holes must be
Echofish 600 – Installation & Operation manual
6