Remedy Of Faults; Wear Parts - Oase HeatUp 25 Instrucciones De Uso Y Garantía

How to proceed:
 E
•
Use a screwdriver for the calibration or break
the supplied tool out of the holder.
•
Measured temperature is too high: Keep the
temperature controller at the set value and

REMEDY OF FAULTS

Malfunction
The water does not heat up. No mains voltage
Water does not reach the
set temperature.
CLEANING
If necessary, clean the unit with clear water using
a soft sponge or cloth.
•
Do not not use cleaning agents or chemical
solutions.

WEAR PARTS

The following components are wear parts and
are excluded from the warranty:
•
Suction cup
Cause
Unit defective
Insufficient water circulation
Unit is not calibrated.
The heating capacity of the unit is
not sufficient with regards to the
ambient temperature or water vol-
ume to be heated up.
move the calibration controller in the direc-
tion of - (minus).
•
Measured temperature is too low: Keep the
temperature controller at the set value and
move the calibration controller in the direc-
tion of + (plus).
Remedy
Check the mains voltage.
Replace unit
Check the temperature.
Calibrate the unit.
Select a suitable unit.
DISPOSAL
Do not dispose of this unit with domestic waste!
For disposal purposes, please use the return sys-
tem provided. Render the unit unusable before-
hand by cutting the cables.
GUARANTEE
For this OASE unit purchased by you, OASE
GmbH assumes a 36 month manufacturer's
- EN -
17