Rowenta AQUAPERFECT SO7050F0 Manual De Instrucciones página 9

NOT SO7010-50 CD060021.qxd
SO7050 MODEL:
1
Start/Stop:
1a/ Starting your appliance:
Connect your appliance to a wall socket. your appliance is powered (in the stand by position), the
Then press the button.
your appliance starts, the display panel lights up. Note: a beep will be emitted by the appliance each time that the control buttons are used or pressed.
1b/ Stopping your appliance: Press the
your appliance remains powered (in stand by position), the
2 The operating modes: Press the MODE button to select your operating mode.
On the control panel:
The operating mode indicator chosen lights up.
2a/ "AUTO" MODE: Set the temperature to between 7°C and 35°C using the
dated after a few seconds.
You can see on the panel:
After a few seconds SELECT disappears, you can then read the temperature of the room in the "HOUSE" icon.
To display your temperature setting, simply press the
Note: If the temperature you have set is lower than that of the room (measured at the appliance) then the appliance stops automatically. The icon underneath the AUTO mes-
sage on the display panel then flashes. The appliance starts heating again automatically as soon as the temperature of the room drops below the temperature set.
2b/ « » MODE : The appliance operates in cold ventilation.
You cannot set the temperature in this operating mode.
2c/ « ECO » MODE : The appliance operates at a power setting of 1200W and automatically sets the temperature to 19°C.
You cannot set the temperature in this operating mode.
You can see on the panel:
The temperature of the room in the "HOUSE" icon.
2d/ "2400W" MODE :
The appliance operates at a power setting of 2400W unregulated.
You cannot set the temperature in this operating mode.
You can see on the panel: The temperature of the room in the "HOUSE" icon.
3
Additional functions:
These functions can only be activated when the appliance is operating.
3a/ « » OSCILLATION :
Press the button. the oscillation function is active.
You can see on the panel: The icon on the oscillation function.
Press the button again. the oscillation function is deactivated.
3b/ CLOCK : Your appliance is equipped with a clock that must be set in order to use the PROG 24h function.
The steps for setting the clock are as follows:
Press the button .
1
(long press).
Press the or
2 To set the hours of the clock. Then validate
by pressing the
Press the or
To set the minutes of the clock. Then
3
validate by pressing the
The clock is now set
Note: check your clock regularly.
3c/ " PROG 24h" PROGRAMMED STARTING AND STOPPING:
Your appliance is equipped with a function permitting several operation ranges to be set (7 ranges) over a period of 24 hours and thus ensure automatic starting and stopping
every day.
The programming steps for "PROG 24H" are as follows:
Note: at any point during programming you can:
- Exit the programming by pressing the PROG 24h button (short press).
- Return to the previous programming step by pressing the ANNUL button.
30/06/06 11:06 Page 10
button.
button is lit.
buttons
buttons
button.
buttons
button.
button is lit.
and buttons; this temperature depends on your idea of comfort. it is automatically vali-
On the panel, you can now see:
The hours of the clock flashing.
On the panel, you can now see:
The minutes of the clock flashing.
GB